Bonus Tolerance: Maximum-Material Size, Actual Sizes, an Inspection Table and Virtual Condition
This lesson is part of the course
In this lesson
You add bonus tolerance from the actual hole size, judge twelve fictional parts on size and position, and compare the virtual conditions of a hole and its mating pin.
Buy the course once for $9.99 to unlock every lesson and lab, the final exam and the certificate – lifetime access, no subscription.
Lessons in this course
- Limits and Tolerances: Nominal Size, Deviations, Maximum and Minimum SizeFree
- Fits from a Fit Table: Hole and Shaft Limits, Clearance, Transition and Interference Locked
- Loop Diagrams: Turning an Assembly into a Chain of Plus and Minus Dimensions Locked
- Worst-Case Stack-Up: Minimum and Maximum Gap, Tolerance Sum and What to Tighten First Locked
- Statistical Stack-Up: Root Sum Square, an Inflation Factor and Each Part's Share Locked
- Position Tolerances: Measured Offsets, Diametral Zones and Square vs Round Zones Locked
- Bonus Tolerance: Maximum-Material Size, Actual Sizes, an Inspection Table and Virtual Condition Locked
- Capstone: Allocating Tolerances at the Lowest Cost Locked