Timers: On-Delay, Off-Delay and Retentive, Milliseconds per Scan
This lesson is part of the course
In this lesson
You run three toy timers over 10 scans of a fill request with uneven scan times: an on-delay that resets when the request drops, an off-delay that keeps its output on after the request drops, and a retentive timer that keeps its time until a reset.
Buy the course once for $9.99 to unlock every lesson and lab, the final exam and the certificate – lifetime access, no subscription.
Lessons in this course
- Contacts and Coils as 0/1 Cells: Normally Open, Normally Closed, Series & Parallel Locked
- Seal-In Circuits: Start/Stop with a Holding Contact, Scan by Scan Locked
- The Scan Cycle: Read Inputs, Solve Rungs, Write Outputs & the One-Scan Delay Locked
- Edge Detection: Rising and Falling Edges, One Count per Press Locked
- Timers: On-Delay, Off-Delay and Retentive, Milliseconds per Scan Locked
- Counters: Up/Down Counting on Edges, Reset, Box Presets and Wrap-Around Locked
- Step Sequences: A Mixing-Tank Cycle as Numbered Steps and Transitions Locked
- Capstone – Alarms & Permissives: Latch, Acknowledge, First-Out and a State Chart Locked