Tolerances & Limits: Max/Min Sizes, Pass/Fail and Fits
This lesson is part of the course
In this lesson
You turn eight toleranced dimensions into upper and lower limits, grade measured parts PASS or FAIL with IF and AND, and classify a hole-and-shaft fit from its clearances.
Buy the course once for $9.99 to unlock every lesson and lab, the final exam and the certificate – lifetime access, no subscription.
Lessons in this course
- Inch, Millimetre & Fraction Conversions for the Shop Floor Locked
- Spindle RPM from Surface Speed: SFM, m/min & Tool Diameter Locked
- Feed Rate: IPM = RPM × Chip Load × Flutes, Cut Time & MRR Locked
- Tolerances & Limits: Max/Min Sizes, Pass/Fail and Fits Locked
- Bolt Circle Coordinates with SIN, COS & a Scatter Plot Locked
- Taper Calculations: Taper per Inch, per Foot, Angle with ATAN & Tailstock Offset Locked
- Drill Point Depth & Sine Bar Setups Locked
- Cycle Time & Job Quote with a Chart Locked